There is a small hole beside the mesh, marked with R, which is the reset key. Long press for more than 5 seconds is effective. After reset, the device will return to the exit setting, and the password
The horizontal is the output and the vertical is the input.
RS485 corresponding interface on the back panel of the processor is -, +; Connect the corresponding interface of central control host or control terminal respectively.
RS232 corresponding interface on the back panel of the processor: G, Rx, TX; respectively indicating: grounding, receiving command, sending command.
The default IP address of the device is 192.168.1.200, so when setting the network segment, you can set the 192.168.1.xxx network segment.
The scene Settings of the main control device and PC terminal are eight scenes, including scene 1, scene 2, scene 3 and..., scene 8;In the scene setting of device Settings, you can perform the followi
1）Check whether the input-output interface is connected correctly. The upper row of the back panel is the input, and the lower row is the output. Every three pins from left to right represent a channe
First, we should check whether there is a problem with our network cable (ordinary network cable), and then check whether the device and PC are in the same network segment. The initial IP of our devic
Please contact our customer service for firmware upgrade package.
The web page control mode has certain requirements for the browser, it is recommended to use A non-IE core browser access.
9th Floor, 1B, Shangzhi Technology Park, Guangming District, Shenzhen City, Guangdong Province, China